1. In practical experiment, why the percentage of error is increased if we put two symmetrical loads in the beanand decreased if we put one load in the center of the load ? 2. Why the highest theoritical shear force is to be found if we place the load at the center of the beam ?if the load are same in all types of concentrated load in s beam.

Respuesta :

Percent errors show the magnitude of our measurement errors during an analysis procedure.

What is the percentage of error?

Percent error calculates the difference between an estimate and a right value and expresses it as a percentage. Analysts can use this statistic to determine how big the error is in relation to the actual number. It is also referred to as % error and percentage error.

Percent errors show the magnitude of our measurement errors during an analysis procedure. We are getting close to the accepted or original value when the percent mistakes are smaller.

The error's absolute value is multiplied by 100%, divided by the accepted value, and then converted to a percent. We can substitute the stated values of 2.45g/cm3 for the experimental value and 2.70g/cm3 for the accepted value to determine the percent error for the aluminum density measurement.

To learn more about the percentage of error refer to:

https://brainly.com/question/1600371

#SPJ4

ACCESS MORE
ACCESS MORE
ACCESS MORE
ACCESS MORE