A mini-PERC RAID Controller requires replacement. What are the steps taken to ensure the RAID controller is installed properly?

Question

19-01-2022
Computers and Technology

contestada

A mini-PERC RAID Controller requires replacement. What are the steps taken to ensure the RAID controller is installed properly?

Respuesta :

ACCESS MORE ACCESS MORE ACCESS MORE ACCESS MORE

Otras preguntas

Come on, man, let me use it,” Alfonso pleaded. “Please, Ernie, I’ll do anything.” Although Ernie could see Alfonso’s desperation, he had plans with his friend R

Please help me solve this short problem guys

What is the cardinal number of the set {-1,3,7,52,36,19,-6}

A new employee has been told to report to her first meeting with the divisional vice president. She is feeling somewhat uncertain about what to expect or how to

There are five cities in a network. The cost of building a road directly between i and j is the entry ai,j in the matrix below. An infinite entry indicates that

Write in standard form (×-3)(x+2)(x-5)

Combine each set of Simple sentences into one Compound sentence.1. He does well. He is nervous at the start.2. The way was long. The wind was cold.3. It is rain

7 root 3 by 3 minus 3 root 2 by root 15 minus 3 root 2 minus 2 root 5 by root 6 + root 5

plz help me with hw A bus of mass 1000 kg moving with a speed of 90km/hr stops after 6 sec by applying brakes then calculate the distance travelled and amount o

Y=(x-7)m solve for x

topeadeniran2 topeadeniran2 · Answer 1 · 2022-01-25T13:51:14+01:00

It should be noted that the step that should be taken to ensure the RAID controller is installed properly will be to angle the mini-PERC card so that one end of the card engages with the cardholder on the system board.

What is a PERC Controller?

A PERC Controller supports hard disk drives and solid-state drives.

To ensure the RAID controller is installed properly will be to angle the mini-PERC card so that one end of the card engages with the cardholder on the system board.

Next, ensure that the guide pins are aligned to the cable and the mini-PERC.

Lastly, secure the two screws, and be careful to not overtighten.

Learn more about cardholder on:

https://brainly.com/question/8190066